96w trc-096 dimmable series switch mode led drivers, constant current electrical specifcations input voltage range: 100-277 vac nom. (90-305 v min/max) frequency: 50/60 hz nom. (47-63 hz min/max) power factor: >0.90 @ full load, 100v through 277v inrush current: 69 a @ 230vac input current: 1.2 a @ 100vac, 0.6 a @ 220vac leakage current: 1 ma @ 277vac maximum power: 96w current accuracy: 1% load regulation: 3% thd: <_ 20% @ full load ripple and noise: 30% io turn-on delay: 1s @ 110vac, 0.8s @ 220vac protection: output over-voltage, short circuit protection with self recovery, over-temperature protection (110c) environmental specifcations minimum starting temp: -35oc storage temperature: -40oc to +85oc maximum case temp. 89c humidity: 10% to 100% cooling: convection sound rating: class a mtbf: 400,000 hours @ 25oc, 80% load, 110vac per mil-hdbk-217f lifetime: 50,000 hours @ 60oc weight: 1.87 lbs (850 g) constant current versions - product specifcations model number output current (ma) output voltage range (vdc) typical effciency (full load, 220vac) trc-096s035dt 350 137-274 91% trc-096s045dt 450 106-213 91% trc-096s070dt 700 68-137 90% trc-096s105dt 1050 46-92 90% TRC-096S140DT 1400 35-69 89% trc-096s175dt 1750 27-54.8 89% trc-096s210dt 2100 22-45.7 88% trc-096s245dt 2450 19-39.1 88% trc-096s280dt 2800 17-34.2 88% trc-096s315dt 3150 15-30.4 87% trc-096s350dt 3500 13-27.4 87% trc-096s400dt 4000 12-24 87% class 2: us/canada us only e332160 ? total power: 96 watts ? input voltage: 100-277 vac nom. ? ul dry, damp & wet location rated ? ip67 ? high effciency ? high power factor with active correction ? output and lightning protection rev 9-1-15 specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 3 ac in(3*awg #18) dc out (2*awg #18) blac k ( a c l ) w h i t e ( a cn) red (v+) blue (v-) g r e e n ( g n d ) ppl(1-10v) dimming control wire (2*awg #22) gray(gnd) tc = 89c max safety and emc compliance ul/cul ul8750, ul1310, ul1012, csa c22.2 no. 223-m91, csa c22.2 no. 107.1 c e en 61347-1, en61347-2-13 en 55015 conducted emission en 61000-3-2 harmonic current emissions en 61000-3-3 voltage fuctuations & ficker fcc part 15 class b en 61000-4-2 electrostatic discharge en 61000-4-3 rfe field susceptibility test en 61000-4-4 electrical fast transient en 61000-4-5 surge immunity test: ac power line: line to line 4 kv, line to earth 6 kv en 61000-4-6 conducted radio frequency en 61000-4-8 power frequency magnetic field test en 61000-4-11 voltage dips en 61547 electromagnetic immunity 30 case temperature (c) lifetime (khrs) lifetime / case temperature 0 50 100 150 200 250 300 350 40 50 60 70 80 90 derating curve load (%) ambient temperature (c) 1 20v a c & 220vac 2 77v a c 100% 80% 60% 40% 20% 0% -35 -25 -15 -5 5 15 25 35 45 55 65 75 trc-096 dimming series 50% load pf power factor / load 60% 70% 80% 90% 100% 50% load thd thd / load 60% 70% 80% 90% 100% 1 20v a c 2 77v a c 1 20v a c 2 77v a c 0.50 0.55 0.70 0.65 0.60 0.75 0.90 0.85 0.80 0.95 1.00 0% 15% 10% 5% 20% 25% typical efficiency / load 75% 70% 80% 85% 90% 100% 95% normalized output voltage efficiency 60% 70% 80% 90% 100% 1 20v a c 2 77v a c thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
pg 3 of 3 dimming control details notes: 1. io is actual output current and ir is rated current without dimming control. 2. for the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold (approx. 50% of the max. output voltage for any given model). 3. if the output voltage is maintained above 50% of the maximum output voltage, the dimming control may be operated over the entire 1-10v range with output current varying from 10% to 100% of ir. 4. the dimming signal is allowed to be less than 1v, however, when it is 0-1v, the output current is 10%ir. 5. do not connect the gray dimming control lead to the black output-current lead. parameters minimum typical maximum 10v output voltage 9.8 v 10 v 10.2 v absolute maximum voltage on the 0-10v input pin 0 v 12 v source current on 0-10v input pin 0 ma 0.5 ma value of rin (the resistor inside the led driver which is located between the 1-10v input pin and the vcc output pin) 19.8k 20k 20.2k the dimmer control is operated from an input signal of 1 C 10 vdc. recommended implementations are provided below. vdim (v) normalized output current output current / dimming voltage 0% 20% 40% 60% 80% 100% 0 1 2 3 4 5 6 7 9 8 10 rx (k?) normalized output current io/ir / rx 0% 20% 40% 60% 80% 100% 0 15 30 45 60 75 90 105 120 135 150 165 180 200 220 240 o p tion 1 - d c i n put rin rx vcc 1-10v input (purple) gnd (gray) 1-10vdc v op tion 2 - ex ter n al resis t or trc-096sxxxxdt trc-096sxxxxdt rin vcc 1-10v input (purple) gnd (gray) trc-096 dimming series thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
|
